# OBD-II P0724: Brake Switch B Circuit High

> **Quick Answer:** OBD-II fault code P0724 indicates Brake Switch B Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$162.

- **URL:** https://faultcodes.org/automotive/obd2-p0724
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Brake switch B is the brake signal to the transmission module or a second brake switch channel, used to release the converter clutch, adapt shift strategy on grades and cancel cruise control. Low and high describe the signal voltage, and what that means depends on polarity: GM's converter clutch brake switch is closed at rest (12 V), while Saab's Trionic 8 sees 12 V when braking. Detection is always a plausibility check against driving: the brake reads applied during accelerations or never applied during decelerations. P0724 means the signal stays high. For GM that reads as brake never applied: 2006 transmission modules flag it after eight decelerations without a brake signal of at least 2 s, without MIL. Saab's Trionic 8 flags a brake light signal that reads on while accelerating from 3 to 40 km/h, four times, and disables cruise control. The opposite is P0719.

## Common Symptoms
- Cruise control cannot be activated or switches off
- Unusual shifting, converter clutch behaviour changed
- No downshift on uphill grades (Subaru)
- Brake lights stay off or on

## Most Likely Root Causes
- Brake light switch sticking or misadjusted
- Signal wire shorted to positive (Saab T8) or switch permanently closed (GM)
- Retrofitted trailer or LED lights feeding back
- Module input faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Brake Switch.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Brake Switch.
5. Clear fault memory and run a verification cycle to confirm P0724 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$68 | $43–$162 |
| GBP | £13–£54 | £34–£129 |
| CAD | CA$22–CA$91 | CA$58–CA$218 |
| EUR | €15–€63 | €40–€150 |
| CHF | CHF 17–CHF 72 | CHF 53–CHF 198 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0724?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0724?
DIY replacement parts average $16–$68, while professional service averages $43–$162.

### Will resetting P0724 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

