# OBD-II P0722: Output Shaft Speed Sensor Circuit No Signal

> **Quick Answer:** OBD-II fault code P0722 indicates Output Shaft Speed Sensor Circuit No Signal. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$486.

- **URL:** https://faultcodes.org/automotive/obd2-p0722
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The output shaft speed sensor (Hall or inductive) reports the speed of the transmission output; it gives the gear ratio together with input speed and on many vehicles also the road speed for speedometer and cruise control. P0722 means the output speed signal is missing while the vehicle is driving. GM's 2025 modules flag under 60 rpm for 3.5–5 s with more than 50 Nm torque and check wheel speeds as well; a 2006 GM table flags no output pulse during 6000 input pulses; Ford under 100–200 rpm for 5–30 s; Saab's Aisin box from 4 km/h. GM rates it after one trip. The transmission goes into limp mode, and speedometer and cruise control may stop working. On GM's 10-speed, P0717 and P0722 together point to the shared sensor supply.

## Common Symptoms
- Speedometer reads 0
- Limp mode or fixed gear
- Warning lamp (MIL, transmission)
- Cruise control not working

## Most Likely Root Causes
- Speed sensor faulty (Hall IC or coil open or shorted)
- Connector or harness corroded, chafed or loose pins (with internal sensors also the pass-through connector)
- Metal debris on the sensor magnet or damaged reluctor wheel
- Transmission module or its sensor supply faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Output Speed Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Output Speed Sensor.
5. Clear fault memory and run a verification cycle to confirm P0722 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$204 | $86–$486 |
| GBP | £24–£161 | £69–£387 |
| CAD | CA$41–CA$274 | CA$116–CA$653 |
| EUR | €28–€189 | €80–€450 |
| CHF | CHF 32–CHF 217 | CHF 106–CHF 594 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0722?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0722?
DIY replacement parts average $30–$204, while professional service averages $86–$486.

### Will resetting P0722 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

