# OBD-II P0720: Output Shaft Speed Sensor Circuit

> **Quick Answer:** OBD-II fault code P0720 indicates Output Shaft Speed Sensor Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$486.

- **URL:** https://faultcodes.org/automotive/obd2-p0720
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The output shaft speed sensor (Hall or inductive) reports the speed of the transmission output; it gives the gear ratio together with input speed and on many vehicles also the road speed for speedometer and cruise control. P0720 is the general circuit code. Ford also uses it for 'no signal': while engine and turbine speed show the vehicle moving, the sensor reports under 100–200 rpm for 5–30 s; ZF's 6HP26 in Ford vehicles flags an open or short after 0.6 s. Subaru-based systems (Saab 9-2X) flag an impossible 255 km/h or 0 km/h while driving and light the MIL after two trips, substituting the other sensor. GM does not use P0720 but P0722. Speedometer and cruise control may fail, often with a vehicle speed code as well.

## Common Symptoms
- Speedometer drops out or jumps
- Warning lamp, limp mode or fixed gear
- Harsh shifts, cruise control not working

## Most Likely Root Causes
- Speed sensor faulty (Hall IC or coil open or shorted)
- Connector or harness corroded, chafed or loose pins (with internal sensors also the pass-through connector)
- Metal debris on the sensor magnet or damaged reluctor wheel
- Transmission module or its sensor supply faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Output Speed Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Output Speed Sensor.
5. Clear fault memory and run a verification cycle to confirm P0720 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$204 | $86–$486 |
| GBP | £24–£161 | £69–£387 |
| CAD | CA$41–CA$274 | CA$116–CA$653 |
| EUR | €28–€189 | €80–€450 |
| CHF | CHF 32–CHF 217 | CHF 106–CHF 594 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0720?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0720?
DIY replacement parts average $30–$204, while professional service averages $86–$486.

### Will resetting P0720 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

