# OBD-II P071B: Transmission Mode Switch A Circuit Low

> **Quick Answer:** OBD-II fault code P071B indicates Transmission Mode Switch A Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p071b
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
A transmission mode switch selects an alternative shift schedule such as sport, winter or tow/haul; J2012 does not define which button is A or B. No manufacturer document available to us uses P071A–P071F: GM monitors its analog drive mode switch under its own codes (low below 21–29 % of 5 V, high from 94 %, 200 of 250 samples, two trips), which shows how such buttons are read as coded voltages. P071B means the signal of mode switch A is below its lower limit: with analog, resistor-coded buttons a short to ground, with digital buttons switching to ground a button stuck pressed. The opposite is P071C.

## Common Symptoms
- Mode A cannot be selected or stays active
- Mode indicator missing or flashing
- Transmission stays on the normal shift schedule

## Most Likely Root Causes
- Signal wire shorted to ground
- Button stuck pressed (switching to ground)
- Moisture or dirt in the button
- Control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Transmission Mode Switch.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Transmission Mode Switch.
5. Clear fault memory and run a verification cycle to confirm P071B does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P071B?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P071B?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P071B fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

