# OBD-II P0718: Input/Turbine Shaft Speed Sensor A Circuit Intermittent

> **Quick Answer:** OBD-II fault code P0718 indicates Input/Turbine Shaft Speed Sensor A Circuit Intermittent. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$486.

- **URL:** https://faultcodes.org/automotive/obd2-p0718
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The input or turbine shaft speed sensor – a Hall sensor with square-wave output or an inductive sensor with sine output – reports the speed behind the torque converter. With output and engine speed it gives the actual gear ratio, converter slip and shift timing. P0718 means the signal is present but jumps or drops out briefly. Ford's petrol modules from 2012 to 2023 count 200 turbine speed spikes above 400 rpm with at most 1.5 s between them in a forward gear. GM's Honda-built five-speed of 2006 flags jumps of more than 3 mph per 10 ms three times in 500 ms, after two trips; GM's own transmissions file such jumps under P0716 instead. Loose contacts and electrical interference are the usual causes; shifts become erratic and limp mode may follow at times.

## Common Symptoms
- Occasional harsh or unexpected shifts
- Warning lamp
- Converter clutch applies and releases unevenly
- Limp mode at times

## Most Likely Root Causes
- Loose contact, corroded connector or chafing
- Electrical interference (shielding, ground, added consumers)
- Metal debris on the sensor or loose mounting
- Sensor faulty internally (temperature-dependent)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Input Speed Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Input Speed Sensor.
5. Clear fault memory and run a verification cycle to confirm P0718 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$204 | $86–$486 |
| GBP | £24–£161 | £69–£387 |
| CAD | CA$41–CA$274 | CA$116–CA$653 |
| EUR | €28–€189 | €80–€450 |
| CHF | CHF 32–CHF 217 | CHF 106–CHF 594 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0718?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0718?
DIY replacement parts average $30–$204, while professional service averages $86–$486.

### Will resetting P0718 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

