# OBD-II P0717: Input/Turbine Shaft Speed Sensor A Circuit No Signal

> **Quick Answer:** OBD-II fault code P0717 indicates Input/Turbine Shaft Speed Sensor A Circuit No Signal. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $162–$1620.

- **URL:** https://faultcodes.org/automotive/obd2-p0717
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The input or turbine shaft speed sensor – a Hall sensor with square-wave output or an inductive sensor with sine output – reports the speed behind the torque converter. With output and engine speed it gives the actual gear ratio, converter slip and shift timing. P0717 means there is practically no input speed signal although the vehicle is driving under power. GM's 2025 modules flag under 200 rpm for more than 4 s with torque applied, the 6T70 under 50 rpm for 5 s, the Allison 1000 under 61 rpm with output above 500 rpm; Ford under 200 rpm for 5–30 s; all after one trip. GM calls it 'circuit low voltage', but means missing frequency. On GM's 10-speed both input and output sensors share a supply – P0717 together with P0722 points to that supply rather than two sensors.

## Common Symptoms
- Check engine and/or transmission warning lamp
- Limp mode with fixed gear, harsh shifts
- Torque converter clutch does not apply
- Input speed shows 0 or implausible in the scan tool

## Most Likely Root Causes
- Speed sensor faulty (Hall IC or coil open or shorted)
- Connector or harness corroded, chafed or loose pins (with internal sensors also the pass-through connector)
- Metal debris on the sensor magnet or damaged reluctor wheel
- Transmission module or its sensor supply faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Input Speed Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Input Speed Sensor.
5. Clear fault memory and run a verification cycle to confirm P0717 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $57–$680 | $162–$1620 |
| GBP | £45–£536 | £129–£1290 |
| CAD | CA$77–CA$914 | CA$218–CA$2175 |
| EUR | €53–€630 | €150–€1500 |
| CHF | CHF 61–CHF 725 | CHF 198–CHF 1980 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0717?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0717?
DIY replacement parts average $57–$680, while professional service averages $162–$1620.

### Will resetting P0717 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

