# OBD-II P0716: Input/Turbine Shaft Speed Sensor A Circuit Range/Performance

> **Quick Answer:** OBD-II fault code P0716 indicates Input/Turbine Shaft Speed Sensor A Circuit Range/Performance. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $162–$1620.

- **URL:** https://faultcodes.org/automotive/obd2-p0716
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The input or turbine shaft speed sensor – a Hall sensor with square-wave output or an inductive sensor with sine output – reports the speed behind the torque converter. With output and engine speed it gives the actual gear ratio, converter slip and shift timing. P0716 means a signal is present but implausible: too high, or dropping suddenly without recovering. GM's 2025 modules count drops of more than 650 rpm between 25 ms samples and fail after more than three; the 6T70 in the Saab 9-4X flags a 1350 rpm drop for 1 s; the 2007 Allison 1000 also detects noise and swapped sensor wires; all after one trip. Ford's 6R80 flags turbine speed above 7700 rpm. The 6T70 then runs only reverse and fifth gear, with maximum line pressure and no converter clutch.

## Common Symptoms
- Check engine and/or transmission warning lamp
- Limp mode with fixed gear (6T70: reverse and fifth only)
- Harsh or delayed shifts
- Torque converter clutch locked out

## Most Likely Root Causes
- Loose contact or chafing in the sensor circuit
- Sensor faulty, wrong air gap or metal debris
- Reluctor wheel or clutch drum damaged
- Sensor wires swapped after repair or interference

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Input Speed Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Input Speed Sensor.
5. Clear fault memory and run a verification cycle to confirm P0716 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $57–$680 | $162–$1620 |
| GBP | £45–£536 | £129–£1290 |
| CAD | CA$77–CA$914 | CA$218–CA$2175 |
| EUR | €53–€630 | €150–€1500 |
| CHF | CHF 61–CHF 725 | CHF 198–CHF 1980 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0716?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0716?
DIY replacement parts average $57–$680, while professional service averages $162–$1620.

### Will resetting P0716 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

