# OBD-II P0713: Transmission Fluid Temperature Sensor A Circuit High

> **Quick Answer:** OBD-II fault code P0713 indicates Transmission Fluid Temperature Sensor A Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$648.

- **URL:** https://faultcodes.org/automotive/obd2-p0713
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The transmission fluid temperature sensor is an NTC thermistor whose resistance falls as the fluid warms; the module feeds it with 5 V through a resistor. A low signal therefore means very hot or a short to ground, a high signal very cold or an open circuit. P0713 means the signal is too high – the sensor reads extremely cold, or the circuit is open or shorted to positive. GM's 2025 modules flag above 284 kΩ for 5 of 6 s after two trips; the 2007 Allison 1000 −45 °C or below for 2.5 s; Saab's AF40 below −43 °C; Ford above 4.6 V for 5–12 s without MIL. Many require prior running time or a warm engine so a genuine −40 °C cold start does not count (Allison: coolant above 20 °C; Saab: over 10 minutes of driving). The transmission then stays in its cold strategy: open converter clutch, late upshifts.

## Common Symptoms
- Fluid temperature shown around −40 °C
- Converter clutch stays open, late upshifts
- Higher fuel consumption
- Check engine or transmission lamp depending on manufacturer

## Most Likely Root Causes
- Transmission connector loose or corroded, wire open
- Sensor open internally
- Signal wire shorted to positive
- Control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Transmission Fluid Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Transmission Fluid Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0713 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$272 | $86–$648 |
| GBP | £24–£214 | £69–£516 |
| CAD | CA$41–CA$365 | CA$116–CA$870 |
| EUR | €28–€252 | €80–€600 |
| CHF | CHF 32–CHF 290 | CHF 106–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0713?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0713?
DIY replacement parts average $30–$272, while professional service averages $86–$648.

### Will resetting P0713 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

