# OBD-II P0712: Transmission Fluid Temperature Sensor A Circuit Low

> **Quick Answer:** OBD-II fault code P0712 indicates Transmission Fluid Temperature Sensor A Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$648.

- **URL:** https://faultcodes.org/automotive/obd2-p0712
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The transmission fluid temperature sensor is an NTC thermistor whose resistance falls as the fluid warms; the module feeds it with 5 V through a resistor. A low signal therefore means very hot or a short to ground, a high signal very cold or an open circuit. P0712 means the signal is too low – the sensor reads extremely hot, or the signal wire is shorted to ground. GM's 2025 transmission modules flag below 13.5 Ω for 5 of 6 s after two trips; the 2018 LT4 engine module below 17.88 Ω (over 150 °C) without MIL; the 2007 Allison 1000 150 °C or more for 2.5 s; Saab's AF40 over 200 °C; Ford below 0.05 V for 5–12 s without MIL. The module substitutes a value (coolant temperature, 80 °C or a hot mode) and may shift with hot-fluid strategy. Real overheating with a good sensor is P0218.

## Common Symptoms
- Transmission in hot mode (early converter clutch, changed shift points)
- Harsh shifts
- Extremely high fluid temperature shown
- Check engine or transmission lamp depending on manufacturer

## Most Likely Root Causes
- Signal wire shorted to ground (internal harness, chafing)
- Sensor shorted internally
- Transmission actually severely overheated
- Control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Transmission Fluid Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Transmission Fluid Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0712 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$272 | $86–$648 |
| GBP | £24–£214 | £69–£516 |
| CAD | CA$41–CA$365 | CA$116–CA$870 |
| EUR | €28–€252 | €80–€600 |
| CHF | CHF 32–CHF 290 | CHF 106–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0712?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0712?
DIY replacement parts average $30–$272, while professional service averages $86–$648.

### Will resetting P0712 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

