# OBD-II P0710: Transmission Fluid Temperature Sensor A Circuit

> **Quick Answer:** OBD-II fault code P0710 indicates Transmission Fluid Temperature Sensor A Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$648.

- **URL:** https://faultcodes.org/automotive/obd2-p0710
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The transmission fluid temperature sensor is an NTC thermistor whose resistance falls as the fluid warms; the module feeds it with 5 V through a resistor. A low signal therefore means very hot or a short to ground, a high signal very cold or an open circuit. P0710 is the general circuit code used when a manufacturer does not separate low and high. Subaru-based systems (Saab 9-2X) flag 0.1 V or less or 4.7 V or more, light the MIL after two consecutive trips and use 80 °C as substitute. Ford's 2023 diesels use P0710 alongside P0712/P0713 for open and short circuits, without MIL, after 5–12 s, substituting coolant temperature. GM uses only the split codes. With the substitute value the shift quality suffers: harsh shifts and a late converter clutch.

## Common Symptoms
- Harsh or late shifts
- Torque converter clutch applies late or not at all
- Check engine or transmission lamp depending on manufacturer
- Implausible fluid temperature in the scan tool

## Most Likely Root Causes
- Fluid temperature sensor faulty (often part of the internal harness or valve body)
- Transmission connector leaking or corroded, oil in the connector
- Wire open or shorted
- Transmission or engine module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Transmission Fluid Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Transmission Fluid Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P0710 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$272 | $86–$648 |
| GBP | £24–£214 | £69–£516 |
| CAD | CA$41–CA$365 | CA$116–CA$870 |
| EUR | €28–€252 | €80–€600 |
| CHF | CHF 32–CHF 290 | CHF 106–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0710?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0710?
DIY replacement parts average $30–$272, while professional service averages $86–$648.

### Will resetting P0710 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

