# OBD-II P070D: Transmission Fluid Level Sensor Circuit High

> **Quick Answer:** OBD-II fault code P070D indicates Transmission Fluid Level Sensor Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $108–$540.

- **URL:** https://faultcodes.org/automotive/obd2-p070d
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Fluid level sensors in the transmission sump report the oil level to the transmission module as a voltage; an Allison patent converts it to millimetres and only accepts readings with the vehicle at rest, warm fluid, low input speed and a tilt correction. Such sensors are mainly found in heavy automatic transmissions. No manufacturer document available to us uses this code. P070D means the sensor signal is above its upper limit – typically an open signal or ground wire, pulled up inside the module, or a short to positive. Because the oil level does not usually affect emissions directly, a rating without the check engine light is likely; expect a transmission warning or a missing level display. The opposite fault is P070C.

## Common Symptoms
- Fluid level display missing or warning to check transmission fluid
- Usually no driveability problems
- Transmission warning lamp depending on manufacturer

## Most Likely Root Causes
- Wire or connector to the level sensor open
- Sensor faulty (open)
- Signal wire shorted to positive
- Control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Transmission Fluid Level Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Transmission Fluid Level Sensor.
5. Clear fault memory and run a verification cycle to confirm P070D does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $38–$227 | $108–$540 |
| GBP | £30–£179 | £86–£430 |
| CAD | CA$51–CA$305 | CA$145–CA$725 |
| EUR | €35–€210 | €100–€500 |
| CHF | CHF 40–CHF 241 | CHF 132–CHF 660 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P070D?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P070D?
DIY replacement parts average $38–$227, while professional service averages $108–$540.

### Will resetting P070D fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

