# OBD-II P0703: Brake Switch B Circuit

> **Quick Answer:** OBD-II fault code P0703 indicates Brake Switch B Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$162.

- **URL:** https://faultcodes.org/automotive/obd2-p0703
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Transmission & Drivetrain
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Brake switch A is usually the brake light switch, B a second, redundant contact or signal used to cancel cruise control, release the converter clutch, check 'brake before throttle' and for stop-start. Since about 2014 GM receives it as a CAN message from the body module and checks its integrity (rolling counter, protection value: 3 of 10 faulty in 2014, 9 of 17 in 2025) without the check engine light; cruise control is disabled. Subaru-based systems (Saab 9-2X) check the circuit electrically during stops and starts and light the MIL after two trips. An NHTSA investigation of Hyundai and Kia brake light switches lists P0703 with a brake light that stays on. Brake switch A codes are P0571–P0573, disagreement between A and B is P0504.

## Common Symptoms
- Cruise control cannot be engaged or drops out
- Brake light stays on or does not work
- Selector cannot be moved out of P (shift lock)
- Check engine light depending on the maker

## Most Likely Root Causes
- Brake light or double switch worn, corroded or misadjusted
- Wiring or connector at the pedal damaged, fuse blown
- CAN message from the body module disturbed (GM: software, bus fault)
- Aftermarket LED lamps or trailer module distorting the circuit

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Brake Switch.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Brake Switch.
5. Clear fault memory and run a verification cycle to confirm P0703 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$68 | $43–$162 |
| GBP | £13–£54 | £34–£129 |
| CAD | CA$22–CA$91 | CA$58–CA$218 |
| EUR | €15–€63 | €40–€150 |
| CHF | CHF 17–CHF 72 | CHF 53–CHF 198 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0703?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0703?
DIY replacement parts average $16–$68, while professional service averages $43–$162.

### Will resetting P0703 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

