# OBD-II P049E: EGR B Control Position Exceeded Learning Limit

> **Quick Answer:** OBD-II fault code P049E indicates EGR B Control Position Exceeded Learning Limit. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$1080.

- **URL:** https://faultcodes.org/automotive/obd2-p049e
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. Circuit B is the second EGR path; on diesels with two circuits it is the low-pressure EGR, which takes exhaust after the particulate filter and feeds it in before the turbo compressor (GM diesels 2016–18, FCA's 2.2 and 3.0 diesels). P049E is the counterpart of P049D for valve B: the learned zero point of its position sensor lies outside the permitted window. GM lists it only in a fault group of its low-pressure EGR (whose position sensor is sensor C there, P044C/P044D), and in the 2016 calibration it is explicitly disabled; thresholds are not published. The description therefore follows GM's P049D strategy by analogy. Low-pressure EGR position control is then switched off.

## Common Symptoms
- Check engine light on
- EGR switched off, usually no noticeable change
- Higher NOx

## Most Likely Root Causes
- Low-pressure EGR valve sooted, does not close fully
- Position sensor of the low-pressure valve faulty or shifted
- Valve replaced without teaching in
- Harness or connector of the low-pressure valve

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Low Pressure Egr Valve.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Low Pressure Egr Valve.
5. Clear fault memory and run a verification cycle to confirm P049E does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$454 | $43–$1080 |
| GBP | £13–£357 | £34–£860 |
| CAD | CA$22–CA$609 | CA$58–CA$1450 |
| EUR | €15–€420 | €40–€1000 |
| CHF | CHF 17–CHF 483 | CHF 53–CHF 1320 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P049E?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P049E?
DIY replacement parts average $16–$454, while professional service averages $43–$1080.

### Will resetting P049E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

