# OBD-II P049C: EGR B Flow Excessive Detected

> **Quick Answer:** OBD-II fault code P049C indicates EGR B Flow Excessive Detected. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $162–$1620.

- **URL:** https://faultcodes.org/automotive/obd2-p049c
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. Circuit B is the second EGR path; on diesels with two circuits it is the low-pressure EGR, which takes exhaust after the particulate filter and feeds it in before the turbo compressor (GM diesels 2016–18, FCA's 2.2 and 3.0 diesels). P049C means too much flow in circuit B – fresh air mass drops further than modelled, or EGR flows with the low-pressure valve closed; CARB explicitly requires a leaking valve to be detected. No manufacturer document available to us uses P049C; the closest is FCA's P045E for a low-pressure valve stuck open. Smoke, lack of power and rough idle follow, and low-pressure EGR is switched off.

## Common Symptoms
- Check engine light on
- Lack of power, black smoke
- Rough idle or misfire, in extreme cases stalling

## Most Likely Root Causes
- Low-pressure EGR valve stuck open or not sealing (soot)
- Position sensor B implausible (valve seemingly closed)
- Leak between exhaust side and intake
- Air mass meter reading too low

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Low Pressure Egr Valve.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Low Pressure Egr Valve.
5. Clear fault memory and run a verification cycle to confirm P049C does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $57–$680 | $162–$1620 |
| GBP | £45–£536 | £129–£1290 |
| CAD | CA$77–CA$914 | CA$218–CA$2175 |
| EUR | €53–€630 | €150–€1500 |
| CHF | CHF 61–CHF 725 | CHF 198–CHF 1980 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P049C?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P049C?
DIY replacement parts average $57–$680, while professional service averages $162–$1620.

### Will resetting P049C fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

