# OBD-II P0499: EVAP System Vent Valve Control Circuit High

> **Quick Answer:** OBD-II fault code P0499 indicates EVAP System Vent Valve Control Circuit High. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0499
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. The vent valve is normally open and switched to ground by the module (GM scheme P0449/P0498/P0499; Ford uses P0446). P0499 means the control wire is shorted to positive: with the driver on the output stays high – GM sees 0.5 Ω or less to the supply, Saab above 4.6 V; MIL after two trips. The valve then cannot close, the system cannot be sealed, and the leak tests are suspended because they would otherwise report a large leak.

## Common Symptoms
- Check engine light on
- EVAP readiness not set
- Usually no change in driving

## Most Likely Root Causes
- Control wire touching battery positive or the valve supply (chafed harness)
- Vent valve coil with shorted turns, driver switches off
- Moisture or corrosion in the connector
- Driver in the engine module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Evap Vent Valve.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Evap Vent Valve.
5. Clear fault memory and run a verification cycle to confirm P0499 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0499?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0499?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P0499 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

