# OBD-II P0498: EVAP System Vent Valve Control Circuit Low

> **Quick Answer:** OBD-II fault code P0498 indicates EVAP System Vent Valve Control Circuit Low. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0498
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. The vent valve is normally open and switched to ground by the module; P0449 (open), P0498 and P0499 form the newer code scheme for its circuit, used mainly by GM and Saab models with GM engines, while Ford uses P0446. P0498 means the control wire is shorted to ground: GM sees 0.5 Ω or less to ground with the driver off (20 of 25 samples), Saab below 2.6 V – MIL after two trips. The valve is then permanently energised and closed, so the tank is not vented and refuelling becomes difficult.

## Common Symptoms
- Check engine light on
- Refuelling difficult, nozzle clicks off
- Vacuum noise when opening the fuel cap

## Most Likely Root Causes
- Vent valve control wire chafed against ground (underbody, tank area)
- Vent valve coil shorted internally
- Corrosion or water in the connector
- Driver in the engine module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Evap Vent Valve.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Evap Vent Valve.
5. Clear fault memory and run a verification cycle to confirm P0498 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0498?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0498?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P0498 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

