# OBD-II P044B: EGR Sensor C Circuit Range/Performance

> **Quick Answer:** OBD-II fault code P044B indicates EGR Sensor C Circuit Range/Performance. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p044b
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. What EGR sensor C is depends on the maker: on Ford petrol engines from 2020 it is the DPFE sensor, which measures the pressure drop across an orifice in the EGR pipe (sensor A there is the valve position sensor); GM diesels assign it to the position sensor of a low-pressure EGR valve, but only within fault groups. P044B means its signal is electrically valid but implausible – for example a pressure difference with the valve closed, or no reaction when it opens. No manufacturer document available to us uses this code; Ford checks the DPFE plausibility under its own codes P139A–P139C (hoses swapped, front or rear hose off or blocked). EGR flow diagnosis is then suspended.

## Common Symptoms
- Check engine light on
- Usually no change in driving
- EGR readiness not set, EGR possibly switched off

## Most Likely Root Causes
- Pressure hoses off, swapped or blocked (soot, condensate)
- Sensor zero point drifted
- Orifice or EGR pipe coked
- Contact resistance in the connector

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Egr Sensor C.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Egr Sensor C.
5. Clear fault memory and run a verification cycle to confirm P044B does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P044B?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P044B?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P044B fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

