# OBD-II P0444: EVAP System Purge Control Valve A Circuit Open

> **Quick Answer:** OBD-II fault code P0444 indicates EVAP System Purge Control Valve A Circuit Open. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$216.

- **URL:** https://faultcodes.org/automotive/obd2-p0444
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0444 belongs to the older scheme of circuit, open and shorted codes for purge valve A; Saab's Trionic T7 and VW use it, while GM reports an open circuit as P0443 and Ford covers everything in P0443. Saab checks with the output switched off: below 2 V the supply through the coil is missing or the line is grounded – Saab combines both under P0444, sets it after about 1 s and pauses the check until the next drive. Purging then stops.

## Common Symptoms
- Check engine light on
- Possibly fuel smell
- EVAP monitors do not run

## Most Likely Root Causes
- Purge valve connector off or corroded
- Valve coil open
- Supply wire, fuse, main relay or control wire open
- Control wire shorted to ground (Saab definition)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Evap Purge Valve.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Evap Purge Valve.
5. Clear fault memory and run a verification cycle to confirm P0444 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$91 | $43–$216 |
| GBP | £13–£71 | £34–£172 |
| CAD | CA$22–CA$122 | CA$58–CA$290 |
| EUR | €15–€84 | €40–€200 |
| CHF | CHF 17–CHF 97 | CHF 53–CHF 264 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0444?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0444?
DIY replacement parts average $16–$91, while professional service averages $43–$216.

### Will resetting P0444 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

