# OBD-II P0443: EVAP System Purge Control Valve A Circuit

> **Quick Answer:** OBD-II fault code P0443 indicates EVAP System Purge Control Valve A Circuit. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0443
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** EVAP Emissions Control
- **Severity:** Low — Minor Issue
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0443 is the electrical check of purge valve A, which the module switches to ground in pulses; it compares the driver's feedback voltage with the commanded state. GM uses it for an open circuit (200 kΩ or more, 20 of 25 samples, MIL after two trips) and reports shorts as P0458/P0459; Ford covers open and short in P0443 (5 s). Purging then stops, the canister is no longer regenerated, and the leak and purge monitors are suspended.

## Common Symptoms
- Check engine light on
- Possibly fuel smell (no purging)
- EVAP leak test does not run

## Most Likely Root Causes
- Purge valve connector corroded, loose or off
- Purge valve coil open or shorted
- Control wire broken or chafed, or supply missing (fuse, main relay)
- Driver in the engine module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Evap Purge Valve.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Evap Purge Valve.
5. Clear fault memory and run a verification cycle to confirm P0443 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0443?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0443?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P0443 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

