# OBD-II P043F: EVAP System Leak Detection Reference Orifice High Flow

> **Quick Answer:** OBD-II fault code P043F indicates EVAP System Leak Detection Reference Orifice High Flow. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $108–$648.

- **URL:** https://faultcodes.org/automotive/obd2-p043f
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Catalytic & Exhaust Emissions
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Systems with a leak detection pump (Bosch DM-TL at VW, Audi, BMW and Maserati, Denso's canister pump module at Toyota/Lexus) first measure a reference value with the pump working only through a built-in 0.5 mm (0.020 in) orifice; it is the yardstick for the small-leak test that CARB requires. P043F means the reference measurement shows too much flow – the reference vacuum or pressure does not reach the expected value, because the reference path or changeover valve leaks, the pump is weak, or air enters through leaking valves in the test path. The leak test can then not be judged, since a weak yardstick would hide leaks. GM and Ford do not use the code.

## Common Symptoms
- Check engine light on
- EVAP leak test does not run, readiness not set
- Usually no change in driving

## Most Likely Root Causes
- Leak detection pump faulty (weak pump, leaking changeover valve, liquid damage)
- Purge valve does not seal
- Pump supply or connector (contact resistance, corrosion)
- Leaking hose between pump module and canister

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Evap Leak Detection Pump.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Evap Leak Detection Pump.
5. Clear fault memory and run a verification cycle to confirm P043F does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $38–$272 | $108–$648 |
| GBP | £30–£214 | £86–£516 |
| CAD | CA$51–CA$365 | CA$145–CA$870 |
| EUR | €35–€252 | €100–€600 |
| CHF | CHF 40–CHF 290 | CHF 132–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P043F?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P043F?
DIY replacement parts average $38–$272, while professional service averages $108–$648.

### Will resetting P043F fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

