# OBD-II P043E: EVAP System Leak Detection Reference Orifice Low Flow

> **Quick Answer:** OBD-II fault code P043E indicates EVAP System Leak Detection Reference Orifice Low Flow. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$648.

- **URL:** https://faultcodes.org/automotive/obd2-p043e
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Catalytic & Exhaust Emissions
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Systems with a leak detection pump (Bosch DM-TL at VW, Audi, BMW and Maserati, Denso's canister pump module at Toyota/Lexus) first measure a reference value with the pump working only through a built-in 0.5 mm (0.020 in) orifice; it is the yardstick for the small-leak test that CARB requires. P043E means the reference measurement shows too little flow – the vacuum (or with DM-TL the pressure and pump current) becomes stronger than expected, so the orifice or reference path is partly blocked, often by dirt or liquid after overfilling. GM and Ford do not use the code; Maserati fixed false triggering with software.

## Common Symptoms
- Check engine light on
- EVAP leak test does not run, readiness not set
- Usually no change in driving

## Most Likely Root Causes
- Reference orifice or pump module dirty or blocked by liquid (overfilled tank, splash water)
- Leak detection pump faulty (weak or blocking pump, changeover valve stuck)
- Engine module software (false detection)
- Pump connector or supply (voltage dip)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Evap Leak Detection Pump.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Evap Leak Detection Pump.
5. Clear fault memory and run a verification cycle to confirm P043E does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$272 | $43–$648 |
| GBP | £13–£214 | £34–£516 |
| CAD | CA$22–CA$365 | CA$58–CA$870 |
| EUR | €15–€252 | €40–€600 |
| CHF | CHF 17–CHF 290 | CHF 53–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P043E?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P043E?
DIY replacement parts average $16–$272, while professional service averages $43–$648.

### Will resetting P043E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

