# OBD-II P0437: Catalyst Temperature Sensor Circuit Low Bank 2 Sensor 1

> **Quick Answer:** OBD-II fault code P0437 indicates Catalyst Temperature Sensor Circuit Low Bank 2 Sensor 1. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p0437
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Catalytic & Exhaust Emissions
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Some engines – mainly diesels – measure the temperature at or in the catalyst with a thermistor in a voltage divider instead of only modelling it; most makers report exhaust temperature sensors under P0544 ff, P2031 ff or P2080 ff instead. Sensor 1 of bank 2 is the first catalyst temperature sensor on the side without cylinder 1. P0437 means the signal voltage is below its lower limit – typically the signal wire is shorted to ground or the sensor is shorted internally. No manufacturer document available to us uses this code; the description follows CARB, which requires input circuits to be checked for circuit faults and plausibility, and the comparable exhaust temperature sensors.

## Common Symptoms
- Check engine light on
- Usually no noticeable change (substitute value from the model)
- Diesel: filter regeneration distorted or blocked, possibly further codes such as P2459 or P0420

## Most Likely Root Causes
- Signal wire shorted to ground (chafed)
- Sensor shorted internally
- Water or corrosion in the connector
- Engine module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Catalyst Temperature Sensor B2S1.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Catalyst Temperature Sensor B2S1.
5. Clear fault memory and run a verification cycle to confirm P0437 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$136 | $65–$324 |
| GBP | £18–£107 | £52–£258 |
| CAD | CA$30–CA$183 | CA$87–CA$435 |
| EUR | €21–€126 | €60–€300 |
| CHF | CHF 24–CHF 145 | CHF 79–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0437?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0437?
DIY replacement parts average $23–$136, while professional service averages $65–$324.

### Will resetting P0437 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

