# OBD-II P0426: Catalyst Temperature Sensor Circuit Range/Performance Bank 1 Sensor 1

> **Quick Answer:** OBD-II fault code P0426 indicates Catalyst Temperature Sensor Circuit Range/Performance Bank 1 Sensor 1. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0426
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Catalytic & Exhaust Emissions
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Some engines – mainly diesels – measure the temperature at or in the catalyst with a thermistor in a voltage divider instead of only modelling it; most makers report exhaust temperature sensors under P0544 ff, P2031 ff or P2080 ff instead. Sensor 1 of bank 1 is the first catalyst temperature sensor on the side with cylinder 1. P0426 means the signal is electrically valid but implausible – compared with the temperature model or neighbouring exhaust sensors it is off, sluggish or frozen. Only FCA's 3.0-litre EcoDiesel (Ram 1500 and Jeep Grand Cherokee, 2014/15) is documented with this sensor: it sits in the middle of the oxidation catalyst and particulate filter unit, a platinum element with 200–240 Ω at room temperature; the bulletin for P0426 advises blowing soot off the tip, measuring and replacing it, plus a software update.

## Common Symptoms
- Check engine light on
- Usually no noticeable change (substitute value from the model)
- Diesel: filter regeneration distorted or blocked, possibly further codes such as P2459 or P0420

## Most Likely Root Causes
- Soot on the sensor tip (diesel)
- Sensor aged, characteristic drifted
- Contact resistance in connector or wiring
- Engine module software (plausibility limits)
- Exhaust leak upstream of the sensor

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Catalyst Temperature Sensor B1S1.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Catalyst Temperature Sensor B1S1.
5. Clear fault memory and run a verification cycle to confirm P0426 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0426?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0426?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P0426 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

