# OBD-II P0421: Catalyst 1 Efficiency Below Threshold Bank 1

> **Quick Answer:** OBD-II fault code P0421 indicates Catalyst 1 Efficiency Below Threshold Bank 1. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $270–$2160.

- **URL:** https://faultcodes.org/automotive/obd2-p0421
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Catalytic & Exhaust Emissions
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Catalyst 1 is the first catalyst in the flow direction of bank 1 (the side with cylinder 1) – the close-coupled or warm-up catalyst that lights off first after a cold start; the older wording was Warm Up Catalyst. P0421 means it no longer converts enough. Mitsubishi V6 engines with manifold catalysts and GM's 3.0/3.2-litre V6 of 2004/05 with Bosch control report it: the rear sensor amplitude is compared with a model, and a quality factor above 0.625 (2004) or 0.375 (2005) sets the code after two trips. GM's small diesels use P0421 for the close-coupled oxidation catalyst, tested by heat balance during filter regeneration.

## Common Symptoms
- Check engine light on, otherwise often no change in driving
- Emission test failed (higher HC, CO, NOx)
- Rattling or loss of power if the catalyst has broken up

## Most Likely Root Causes
- Close-coupled catalyst aged, overheated or coating detached
- Misfire or rich running as prior damage
- Sensor after the close-coupled catalyst sluggish or faulty
- Engine module software (Mitsubishi: update for 2006 Eclipse V6)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Close Coupled Catalyst.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Close Coupled Catalyst.
5. Clear fault memory and run a verification cycle to confirm P0421 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $95–$907 | $270–$2160 |
| GBP | £75–£714 | £215–£1720 |
| CAD | CA$128–CA$1218 | CA$363–CA$2900 |
| EUR | €88–€840 | €250–€2000 |
| CHF | CHF 101–CHF 966 | CHF 330–CHF 2640 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0421?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0421?
DIY replacement parts average $95–$907, while professional service averages $270–$2160.

### Will resetting P0421 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

