# OBD-II P0328: Knock/Combustion Vibration Sensor A Circuit High

> **Quick Answer:** OBD-II fault code P0328 indicates Knock/Combustion Vibration Sensor A Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$648.

- **URL:** https://faultcodes.org/automotive/obd2-p0328
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The knock sensor is a piezoelectric structure-borne sound sensor bolted to the engine block; the module evaluates its signal per cylinder and retards ignition when it detects knock. Sensor A is the first sensor (bank 1 or a single sensor). With a fault the module retards ignition across the board as protection – noticeable loss of power and higher consumption. P0328 means the diagnostic DC voltage at the sensor input is too high – typically a short to voltage. GM sets it above 39 % of 5 V in 50 of 63 samples, in the first trip; Ford checks actively once every 250 engine cycles on modules with this circuit.

## Common Symptoms
- Check engine light on
- Loss of power, sluggish response from ignition retard
- Higher fuel consumption

## Most Likely Root Causes
- Signal or return wire shorted to voltage
- Corrosion or moisture in the connector
- Sensor faulty internally
- Engine module internal

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Knock Sensor A.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Knock Sensor A.
5. Clear fault memory and run a verification cycle to confirm P0328 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$272 | $43–$648 |
| GBP | £13–£214 | £34–£516 |
| CAD | CA$22–CA$365 | CA$58–CA$870 |
| EUR | €15–€252 | €40–€600 |
| CHF | CHF 17–CHF 290 | CHF 53–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0328?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0328?
DIY replacement parts average $16–$272, while professional service averages $43–$648.

### Will resetting P0328 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

