# OBD-II P0322: Ignition/Distributor Engine Speed Input Circuit No Signal

> **Quick Answer:** OBD-II fault code P0322 indicates Ignition/Distributor Engine Speed Input Circuit No Signal. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$432.

- **URL:** https://faultcodes.org/automotive/obd2-p0322
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
P0322 means the speed and reference input of the ignition – today the crankshaft position sensor – delivers no signal although the engine is turning. Ford proves the rotation with the camshaft sensor: if it shows more than one engine revolution without a crank signal (from 500 rpm, detected within 5 s), Ford sets P0322 or, depending on the engine, P0335; with electronic throttle the throttle software adds P2106 and goes into limp mode. Without a crank signal there is no ignition or injection, so the engine stalls or does not start. Saab's Motronic 2.8.1 (900 V6) sets P0322 when the engine fails to start; its inductive sensor should measure 500–600 Ω and give 2–5 V AC while cranking. Systems without a camshaft-based check may store no code at all on a total failure.

## Common Symptoms
- Engine cranks but does not start
- Engine stalls while driving
- Tachometer shows zero
- Check engine light on, with electronic throttle limp mode (P2106)

## Most Likely Root Causes
- Crankshaft position sensor failed (often heat-related)
- Open or short in signal, ground or 5 V supply, corroded connector
- Sensor loose, air gap too large or tone wheel damaged
- 5 V reference pulled down by another sensor on the same supply
- Engine module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Crankshaft Position Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Crankshaft Position Sensor.
5. Clear fault memory and run a verification cycle to confirm P0322 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$181 | $65–$432 |
| GBP | £18–£143 | £52–£344 |
| CAD | CA$30–CA$244 | CA$87–CA$580 |
| EUR | €21–€168 | €60–€400 |
| CHF | CHF 24–CHF 193 | CHF 79–CHF 528 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0322?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0322?
DIY replacement parts average $23–$181, while professional service averages $65–$432.

### Will resetting P0322 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

