# OBD-II P0321: Ignition/Distributor Engine Speed Input Circuit Range/Performance

> **Quick Answer:** OBD-II fault code P0321 indicates Ignition/Distributor Engine Speed Input Circuit Range/Performance. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $65–$378.

- **URL:** https://faultcodes.org/automotive/obd2-p0321
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
P0321 belongs to the same signal as P0320 and P0322: the speed and reference input of the ignition, formerly the distributor's Hall pickup, today practically always the crankshaft position sensor. Range/Performance means a signal is present but implausible – wrong number of teeth between the reference gaps, erratic tooth times, or a speed that does not fit the camshaft signal. No manufacturer document available to us describes P0321 by code: Ford runs these tooth checks under P0320 or P0339 (wrong tooth count after the gap, tooth time outside 30 to 9,000 rpm, gap at the wrong position) and GM under P0336. The description therefore follows that logic and CARB's rationality requirement for crank angle sensors.

## Common Symptoms
- Check engine light on
- Jerking, misfire or brief stalling
- Hard starting, long cranking
- Tachometer flickers or drops out

## Most Likely Root Causes
- Crankshaft position sensor faulty or aged (weak, noisy signal)
- Sensor loose or air gap wrong
- Tone wheel damaged or clogged with metal chips
- Interference, poor ground or damaged wiring
- Engine module or software

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Crankshaft Position Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Crankshaft Position Sensor.
5. Clear fault memory and run a verification cycle to confirm P0321 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$159 | $65–$378 |
| GBP | £18–£125 | £52–£301 |
| CAD | CA$30–CA$213 | CA$87–CA$508 |
| EUR | €21–€147 | €60–€350 |
| CHF | CHF 24–CHF 169 | CHF 79–CHF 462 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0321?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0321?
DIY replacement parts average $23–$159, while professional service averages $65–$378.

### Will resetting P0321 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

