# OBD-II P0320: Ignition/Distributor Engine Speed Input Circuit

> **Quick Answer:** OBD-II fault code P0320 indicates Ignition/Distributor Engine Speed Input Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$378.

- **URL:** https://faultcodes.org/automotive/obd2-p0320
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
P0320 originally covered the engine speed signal from the distributor or ignition module to the engine module (early OBD II); today Ford's engine module evaluates the crankshaft sensor directly and uses this code for it. Ford checks continuously from 200–500 rpm and sets it within 5 s when the number of teeth after the gap is wrong, the tooth time is implausible (below 30 or above 9,000 rpm) or the gap appears in the wrong place; fuel and spark are then cut briefly to resynchronise, and on electronic throttle P2106 limits power. Some Ford engines use P0339 instead. Typical causes are a faulty crankshaft sensor, interference in the wiring or a damaged tone wheel.

## Common Symptoms
- Check engine light on
- Engine dies or stumbles briefly
- Starting problems, tachometer twitching
- Reduced power on electronic throttle (Ford P2106)

## Most Likely Root Causes
- Crankshaft or distributor speed sensor faulty or wrong air gap
- Wiring, connector or shielding disturbed (loose contact, interference from ignition or radios)
- Tone wheel damaged or dirty (missing tooth, metal chips)
- Ignition module faulty on older vehicles
- Engine module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Crankshaft Position Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Crankshaft Position Sensor.
5. Clear fault memory and run a verification cycle to confirm P0320 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$159 | $54–$378 |
| GBP | £15–£125 | £43–£301 |
| CAD | CA$26–CA$213 | CA$73–CA$508 |
| EUR | €18–€147 | €50–€350 |
| CHF | CHF 21–CHF 169 | CHF 66–CHF 462 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0320?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0320?
DIY replacement parts average $19–$159, while professional service averages $54–$378.

### Will resetting P0320 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

