# OBD-II P0318: Rough Road Sensor A Signal Circuit

> **Quick Answer:** OBD-II fault code P0318 indicates Rough Road Sensor A Signal Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$432.

- **URL:** https://faultcodes.org/automotive/obd2-p0318
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Misfire detection works from crankshaft speed fluctuations, which rough roads also cause. CARB therefore allows misfire detection to pause on rough roads; many engines take a rough-road signal from the wheel speeds of the ABS module, a Ford patent describes such a detector. P0318 means rough-road signal A is missing or invalid. On GM engines (documented in Saab service information for the 1.6 turbo) the brake control module sends wheel speed over the data bus; the code sets between 1,520 and 4,000 rpm when that module reports a wheel speed sensor fault or no signal arrives for more than 5 s. GM files it without the warning light. Misfire detection then runs without its rough-road filter. ABS or stability warnings and further codes often appear at the same time.

## Common Symptoms
- Service message (GM without warning light)
- Often ABS or stability warning at the same time
- Driving unaffected

## Most Likely Root Causes
- Wheel speed sensor or wiring faulty – the brake module passes on the fault
- Communication between engine and brake module lost (CAN, connector, supply)
- Brake control module faulty
- Separate rough-road sensor faulty, where fitted

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Wheel Speed Sensors.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Wheel Speed Sensors.
5. Clear fault memory and run a verification cycle to confirm P0318 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$181 | $54–$432 |
| GBP | £15–£143 | £43–£344 |
| CAD | CA$26–CA$244 | CA$73–CA$580 |
| EUR | €18–€168 | €50–€400 |
| CHF | CHF 21–CHF 193 | CHF 66–CHF 528 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0318?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0318?
DIY replacement parts average $19–$181, while professional service averages $54–$432.

### Will resetting P0318 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

