# OBD-II P0316: Engine Misfire Detected on Startup (First 1000 Revolutions)

> **Quick Answer:** OBD-II fault code P0316 indicates Engine Misfire Detected on Startup (First 1000 Revolutions). Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$1296.

- **URL:** https://faultcodes.org/automotive/obd2-p0316
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
P0316 concerns misfire within the first 1,000 revolutions after start. CARB requires a pending code here after the first exceedance of the emissions-relevant rate (later in the drive only after the fourth) and the warning light if it recurs at the next start. Ford sets P0316 in addition to the cylinder code; GM evaluates the start within P0300–P0308 without its own code. Typical causes are water in the plug wells (Mazda Tribute bulletin: blocked drain in the valve cover channel), coils that arc when cold and damp, injectors that drip after switch-off and over-rich starting – Ford traced cases on the 2.7 EcoBoost to engine software or leaking direct injectors.

## Common Symptoms
- Check engine light (usually with P0300/P030x)
- Rough running right after a cold start, then normal
- Delayed start, fuel smell at start

## Most Likely Root Causes
- Moisture or water in the plug wells, coils arcing when cold or damp
- Leaking injectors (fuel drips after switch-off, over-rich start)
- Worn or sooted spark plugs that only fire cleanly when warm
- Wrong temperature sensor value or engine software

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Ignition Coils.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Ignition Coils.
5. Clear fault memory and run a verification cycle to confirm P0316 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$544 | $43–$1296 |
| GBP | £13–£428 | £34–£1032 |
| CAD | CA$22–CA$731 | CA$58–CA$1740 |
| EUR | €15–€504 | €40–€1200 |
| CHF | CHF 17–CHF 580 | CHF 53–CHF 1584 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0316?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0316?
DIY replacement parts average $16–$544, while professional service averages $43–$1296.

### Will resetting P0316 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

