# OBD-II P0313: Misfire Detected with Low Fuel

> **Quick Answer:** OBD-II fault code P0313 indicates Misfire Detected with Low Fuel. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$648.

- **URL:** https://faultcodes.org/automotive/obd2-p0313
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
When the tank is nearly empty the fuel pump can draw air in corners or on gradients, which causes misfires. CARB allows misfire detection to be switched off at 15 % fuel or less; some manufacturers instead report misfires detected in this state under P0313 rather than P030x. Ford's normal misfire monitor runs from 15 % fuel, Saab's ME9 from 12 %; Saab's T8 sets P0313 below 5 litres with the same tests as P0300 (3 % per 1,000 revolutions, flashing light at a catalyst-damaging rate). GM petrol engines simply suspend the monitor without their own code. After refuelling the symptoms usually disappear – if not, look for a real misfire cause.

## Common Symptoms
- Check engine light on (flashing at a catalyst-damaging rate)
- Jerking or power loss with an almost empty tank, especially in corners or uphill
- Usually no symptoms after refuelling

## Most Likely Root Causes
- Tank nearly empty – the fuel pump draws air (corners, gradients, braking)
- Actual misfire cause (ignition, injector, false air) that happened at low fuel
- Weak fuel pump, clogged strainer or filter, faulty swirl pot
- Fuel level sender reading too low

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Fuel Pump.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Fuel Pump.
5. Clear fault memory and run a verification cycle to confirm P0313 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$272 | $43–$648 |
| GBP | £13–£214 | £34–£516 |
| CAD | CA$22–CA$365 | CA$58–CA$870 |
| EUR | €15–€252 | €40–€600 |
| CHF | CHF 17–CHF 290 | CHF 53–CHF 792 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0313?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0313?
DIY replacement parts average $16–$272, while professional service averages $43–$648.

### Will resetting P0313 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

