# OBD-II P0310: Cylinder 10 Misfire Detected

> **Quick Answer:** OBD-II fault code P0310 indicates Cylinder 10 Misfire Detected. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$864.

- **URL:** https://faultcodes.org/automotive/obd2-p0310
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The engine module detects misfire from crankshaft speed: a cylinder that does not fire gives no acceleration impulse. At a catalyst-damaging rate (CARB: at least 5 % per 200 revolutions) the warning light flashes; at an emissions-relevant rate (at least 1 % per 1,000 revolutions – GM about 2–5 %, Ford 0.9–1.5 %) it comes on after two trips. Ford and GM may shut off a misfiring cylinder's injector to protect the catalyst. P0310 means more than 90 % of the detected misfires fall on cylinder 10. Usual causes are the ignition coil or spark plug of that cylinder, its injector, or low compression; a quick test is to swap coil or plug with a neighbouring cylinder and see whether the misfire moves. Cylinder 10 exists on ten-cylinder engines such as Ford's 6.8 litre V10; there an under-torqued crankshaft pulley bolt and engine software caused false misfire codes on all cylinders.

## Common Symptoms
- Check engine light on, flashing at a catalyst-damaging rate
- Rough idle, jerking, vibration
- Loss of power, hesitation
- Smell of unburnt fuel, higher consumption

## Most Likely Root Causes
- Ignition coil of cylinder 10 faulty (coil, connector, ground)
- Spark plug of cylinder 10 worn, sooted, cracked or wrongly gapped
- Injector of cylinder 10 clogged or leaking, or its control
- Low compression on cylinder 10 (valve, rings, head gasket) or local false air
- Water or oil in the plug well

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Ignition Coil Cylinder 10.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Ignition Coil Cylinder 10.
5. Clear fault memory and run a verification cycle to confirm P0310 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$363 | $43–$864 |
| GBP | £13–£286 | £34–£688 |
| CAD | CA$22–CA$487 | CA$58–CA$1160 |
| EUR | €15–€336 | €40–€800 |
| CHF | CHF 17–CHF 386 | CHF 53–CHF 1056 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0310?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P0310?
DIY replacement parts average $16–$363, while professional service averages $43–$864.

### Will resetting P0310 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

