# OBD-II P030C: Ignition A Control Signal Circuit High

> **Quick Answer:** OBD-II fault code P030C indicates Ignition A Control Signal Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $54–$540.

- **URL:** https://faultcodes.org/automotive/obd2-p030c
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Ignition A is one of the control signal lines from the engine module to an ignition module, ignition output stage or group of coils; which cylinders it serves is defined by the manufacturer, not by the code standard. The code concerns the logic-level control signal, not the coil's primary current (that has its own codes, P0351 ff and P2300 ff). P030C means the control line reads high – typically shorted to voltage. No manufacturer using these codes was found; GM reports coil control faults as P0351 ff (open above 30 kΩ, first trip), so the description follows CARB and that analogy. The affected coils fire wrongly or not at all, causing misfire; many modules then shut off injection to those cylinders to protect the catalyst.

## Common Symptoms
- Check engine light on
- Misfire, jerking, rough idle
- Loss of power, possibly cylinders shut off
- Additional misfire codes P0300 ff

## Most Likely Root Causes
- Control line shorted to a supply wire
- Ignition module or coil faulty
- Moisture or corrosion in the connector
- Driver stage in the engine module

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Ignition Control A.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Ignition Control A.
5. Clear fault memory and run a verification cycle to confirm P030C does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$227 | $54–$540 |
| GBP | £15–£179 | £43–£430 |
| CAD | CA$26–CA$305 | CA$73–CA$725 |
| EUR | €18–€210 | €50–€500 |
| CHF | CHF 21–CHF 241 | CHF 66–CHF 660 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P030C?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P030C?
DIY replacement parts average $19–$227, while professional service averages $54–$540.

### Will resetting P030C fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

