# OBD-II P0304: OBD-II P0304: Cylinder 4 Misfire Detected

> **Quick Answer:** Code **P0304** (SAE J2012) means the PCM's **Mode `$06` Cylinder 4 misfire counter** detected recurring combustion misfires specifically on **Cylinder 4**. **Safety first: if the Check Engine Light is FLASHING, pull over and shut off the engine immediately**—raw fuel dumping out of Cylinder 4 can quickly overheat and ruin the catalytic converter. Isolate the failing part cleanly before spending money: swap **Cylinder 4 ignition coil -> Cylinder #1 (or #2)** and inspect the **#4 spark plug** for worn gaps or vertical black **carbon tracking** lines on the white ceramic insulator (move it to another cylinder like #3 to confirm). If the misfire stays locked on #4, check **injector coil resistance (`~11–16 Ω` port injection) & noid-light pulse**, then run **compression & leakdown tests** ($25–$180 DIY; $140–$580 shop).

- **URL:** https://faultcodes.org/automotive/obd2-p0304
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T00:00:00Z

## What This Fault Code Means
Using high-resolution Crankshaft Position Sensor (`CKP`) tooth timing, the PCM calculates rotational speed gains right after Cylinder 4 fires. Missing combustion on #4 causes a measurable deceleration dip that increments the **Mode `$06` Cylinder 4 misfire counter**, triggering `P0304` and—under severe catalyst-heating misfires—a **2-Hz flashing CEL** plus injector shutoff.

## Technical Thresholds & Specifications
| Parameter / Condition | Factory Spec / Threshold | Note |
| --- | --- | --- |
| OBD-II Misfire Counter | Mode $06 Cylinder 4 Misfire Counter | Counts crankshaft speed dips tied to Cylinder #4 ignition timing |
| Port Injector Resistance (PFI) | ~11–16 Ω at ambient temperature | Combined with noid-light test to verify injector coil & PCM pulse |
| Compression & Leakdown Rule | ~120–180 psi (within 10–15%) / < 10% leakdown | Identifies burnt valve, head gasket, or ring wear when swap stays on #4 |
| Flashing MIL Safety Limit | Immediate engine shutdown required | Prevents raw unburned fuel from melting catalytic converter brick |

## Commonly Affected Models & Service Bulletins
- Subaru Outback / Forester / Impreza & Toyota Camry / Corolla / RAV4
- Volkswagen / Audi 2.0T TSI, BMW 4-Cylinder & Chevrolet Cruze / Equinox
- Ford Focus / Escape / F-150 & Honda Civic / Accord / CR-V Models

## Common Symptoms
- Rough shuddering idle, heavy vibration under load, and reduced acceleration
- **Steady or flashing Check Engine Light (`P0304`)**—flashing signals immediate catalyst meltdown risk
- Raw gasoline smell from the exhaust and degraded fuel economy

## Most Likely Root Causes
- Failing **Cylinder 4 ignition coil**, cracked rubber boot, or arc marks along the spark plug (**carbon tracking**) (#1 cause)
- Worn or fouled **Cylinder 4 spark plug** (excessive electrode gap) or oil leaking into plug tube #4
- Clogged, leaking, or electrically open **Cylinder 4 fuel injector** (`~11–16 Ω` PFI coil out of spec) or broken driver wire
- Low **Cylinder 4 compression** (burnt valve, blown head gasket—note #4 sits at the rear of many inline-4 engines where coolant/heat stress peaks—or worn rings)

## Tools & Parts Reference
- OBD-II live scanner supporting **Mode $06** cylinder misfire counters
- Spark plug socket (`14 mm` / `16 mm`) + torque wrench + multimeter (`11–16 Ω` injector check)
- Noid light injector tester + **compression & cylinder leakdown tester**

## Step-by-Step Troubleshooting & Fix
1. If black carbon-tracking lines appear on the #4 spark plug ceramic, replace **both the spark plug AND the rubber coil boot/coil** together—otherwise the scored boot immediately burns a carbon path onto the new plug.
2. Replace any failed **ignition coil** or worn **spark plug set** proven by the swap test (plus valve cover tube seals if oil is present).
3. If spark tests healthy yet `P0304` persists on #4, test/replace a clogged or electrically open **Cylinder 4 fuel injector** or fix broken harness wiring back to the PCM.
4. If compression drops `> 10–15%` below neighboring cylinders, run a **cylinder leakdown test** (listening at tailpipe, throttle body, and coolant reservoir) to pinpoint exhaust valve, head gasket, or piston ring repair.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $25–$180 | $140–$580 |
| GBP | £20–£145 | £115–£460 |
| CAD | CA$35–CA$240 | CA$185–CA$760 |
| EUR | €25–€165 | €125–€520 |
| CHF | CHF 35–CHF 220 | CHF 180–CHF 690 |

## Frequently Asked Questions
### What is carbon tracking on a spark plug and why does it cause P0304?
Carbon tracking looks like a thin black lightning streak running vertically down the white ceramic insulator. It happens when a cracked or loose coil boot lets spark voltage jump down the outside of the plug instead of across the gap—if you replace only the plug without the boot, the old boot immediately ruins the new plug.

### Why should Cylinder 4 compression and leakdown be checked if swapping coils and plugs doesn't help?
On many 4-cylinder engines, Cylinder 4 sits farthest from the water pump or next to PCV/brake-booster vacuum ports. If spark and injector pulse test fine, a compression + leakdown test immediately rules out a burnt exhaust valve, intake gasket leak, or head gasket seep.


## Verified Official & Engineering References
- [SAE International: SAE J2012 Diagnostic Trouble Code Standards](https://www.sae.org/standards/content/j2012/) (Regulation / Standard)
- [US EPA On-Board Diagnostics (OBD) Standards](https://www.epa.gov/obd) (Regulation / Standard)
- [California OBD-II Misfire Monitor Rules (13 CCR § 1968.2)](https://www.law.cornell.edu/regulations/california/13-CCR-1968.2) (Official Support)
