# OBD-II P0300: Random / Multiple Cylinder Misfire Detected

> **Quick Answer:** Code P0300 signals random or multi-cylinder engine misfires detected via crankshaft rotation-speed fluctuations. **Do not keep driving if the Check Engine Light is FLASHING**, which signals catalyst-damaging misfires (`>= 5%` per 200 crankshaft revolutions per CARB 13 CCR 1968.2) where Ford/GM ECUs often shut down fuel injectors to prevent melting the catalytic converter. Because P0300 hits multiple cylinders simultaneously, look first for **shared systemic causes** (intake vacuum leaks, worn spark plugs/cracked insulators, weak ignition coils, low fuel pressure, or false misfires from unlearned crankshaft tone wheels) rather than changing a single part ($30–$280 DIY; $190–$850 shop).

- **URL:** https://faultcodes.org/automotive/obd2-p0300
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Ignition & Misfire System
- **Severity:** Critical — Stop Immediately
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T00:00:00Z

## What This Fault Code Means
On every power stroke, the ECM times angular acceleration on the crankshaft sensor. When multiple cylinders each cause `>10%` of misfires, cylinders swap randomly, or high-RPM conditions hide single-cylinder identification, P0300 sets. Emissions-relevant solid MIL trips occur near `>= 1%` per 1,000 revolutions (GM `~2–5%`, Ford `0.9–1.5%`) over two trips, while catalyst-damaging rates (`>= 5%` per 200 revolutions) flash the Check Engine light immediately.

## Technical Thresholds & Specifications
| Parameter / Condition | Factory Spec / Threshold | Note |
| --- | --- | --- |
| Catalyst-Damaging Misfire Rate (Flashing MIL) | >= 5% per 200 crankshaft revolutions | CARB 13 CCR 1968.2 limit; Ford/GM ECUs may shut off affected injectors to protect converter |
| Emissions-Relevant Misfire Rate (Solid MIL) | >= 1% per 1,000 revs (GM ~2–5%, Ford 0.9–1.5%) | Sets solid warning light after 2 consecutive trips with sustained emissions threshold breach |
| P0300 Multi-Cylinder Trigger Logic | > 10% share across multiple cylinders | Triggered when misfires shift randomly or cannot be isolated to a single cylinder at high RPM |

## Commonly Affected Models & Service Bulletins
- Vehicles with overdue spark plugs, wrong plug gap, cracked insulators, or failing coils (NHTSA TSBs MC-10170712, MC-10207925, MC-11005019)
- GM & Ford petrol engines subject to automatic catalyst-protection injector shutoff during flashing MIL
- Platforms experiencing false P0300 detection from damaged crankshaft tone wheels or unlearned CKP variation (`P0315`/`P0316`)

## Common Symptoms
- Rough shuddering idle, violent shaking under acceleration, and distinct power loss
- Flashing Check Engine Light during severe load (immediate warning to lift throttle and pull over)
- Raw gasoline smell from tailpipe and accompanying single-cylinder codes (`P0301–P0308`) or `P0316`

## Most Likely Root Causes
- Worn spark plugs with wide gaps, carbon-tracked boots, or cracked ceramic insulators (highlighted in NHTSA misfire TSBs)
- Shared vacuum leak (`P0171`), failing fuel pump / clogged fuel filter causing multi-cylinder lean starvation
- Failing coil packs (common on multi-coil waste-spark engines), fouled fuel injectors, or bad contaminated gasoline
- Mechanical compression loss, jumped cam timing (`P0016`/`P0017`), OR false misfire detection from an unlearned/damaged crankshaft tone wheel (`P0315`)

## Tools & Parts Reference
- OBD-II scanner supporting Mode $06 live misfire counters
- Spark plug socket, extension & calibrated torque wrench
- Spark plug feeler gap gauge & intake smoke tester
- Compression gauge & fuel pressure test kit

## Step-by-Step Troubleshooting & Fix
1. If Check Engine Light flashes, pull over and inspect/fix before driving—never drive far while raw fuel pours onto a glowing catalytic converter.
2. Fix systemic vacuum leaks (smoke test intake/PCV lines) or low fuel pressure before replacing ignition parts unnecessarily.
3. Replace overdue OEM-heat-range spark plugs, damaged rubber coil boots (check plug-well valve cover gaskets for oil leaks), and confirm proper plug gap.
4. If Mode $06 isolates 1–2 weak cylinders, swap coils to test if misfire counts migrate; if misfires remain smooth mechanically yet counters stay erratic after repairs, run a **Crankshaft Variation Relearn** (`P0315`) and test cylinder compression.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$280 | $190–$850 |
| GBP | £24–£225 | £150–£660 |
| CAD | CA$40–CA$365 | CA$250–CA$1100 |
| EUR | €28–€255 | €175–€770 |
| CHF | CHF 35–CHF 310 | CHF 230–CHF 960 |

## Frequently Asked Questions
### What does a flashing Check Engine light with P0300 mean?
Under CARB/SAE rules, a flashing MIL warns of severe misfire (`>= 5%` of strokes per 200 revolutions) capable of overheating and melting the catalytic converter in minutes—many Ford and GM controllers cut fuel injectors to misfiring cylinders to prevent fire or substrate damage.

### Can rough roads or a bad crankshaft sensor cause a fake P0300?
Yes! Official OBD engineering specs note that damaged crankshaft tone wheels, unlearned CKP variations (`P0315`), or violent suspension vibration over washboard roads can mimic irregular crankshaft acceleration and set P0300.


## Verified Official & Engineering References
- [OBD-II Misfire Threshold Regulation (13 CCR 1968.2)](https://www.law.cornell.edu/regulations/california/13-CCR-1968.2) (Regulation / Standard)
- [GM Engine OBD Mode 6 Misfire Spec (18OBDG03A)](https://gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A%20Engine%20Diagnostics.pdf) (Technical Manual)
- [NHTSA Service Bulletin MC-10170712 (Ignition & Misfire)](https://static.nhtsa.gov/odi/tsbs/2019/MC-10170712-9999.pdf) (Service Bulletin (TSB))
- [NHTSA Service Bulletin MC-11005019 (Misfire Diagnostics)](https://static.nhtsa.gov/odi/tsbs/2024/MC-11005019-0001.pdf) (Service Bulletin (TSB))
