# OBD-II P0147: O2 Sensor Heater Circuit Bank 1 Sensor 3

> **Quick Answer:** OBD-II fault code P0147 indicates O2 Sensor Heater Circuit Bank 1 Sensor 3. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0147
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor 3 is a third oxygen sensor on bank 1, behind a second converter or converter brick. It only exists on some vehicles – documented for Jaguar Land Rover's 3.0 V6 supercharged (2013–2016, where sensor 2 is 'mid-cat' and sensor 3 'post-cat') and Ford systems that monitor part of the converter volume. P0147 concerns its heater. Ford checks the driver voltage continuously and the heater current once per drive cycle once sensor 3 is above about 120 °C and has heated for 30 s – below about 0.22–0.465 A (depending on supplier) or above 3 A counts as a fault; the heater resistance is a separate code (P0055). Jaguar Land Rover lists P0147 for its post-cat sensor. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

## Common Symptoms
- Check engine light on (usually after two drive cycles)
- Follow-up codes for sensor 3 possible
- Usually no noticeable change in driving

## Most Likely Root Causes
- Heater element in the sensor burnt out (replace sensor)
- Heater supply (fuse, relay) or control wire open
- Connector corroded, contact resistance

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Heater Bank1 Sensor3.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Heater Bank1 Sensor3.
5. Clear fault memory and run a verification cycle to confirm P0147 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$113 | $54–$270 |
| GBP | £15–£89 | £43–£215 |
| CAD | CA$26–CA$152 | CA$73–CA$363 |
| EUR | €18–€105 | €50–€250 |
| CHF | CHF 21–CHF 121 | CHF 66–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0147?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0147?
DIY replacement parts average $19–$113, while professional service averages $54–$270.

### Will resetting P0147 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

