# OBD-II P0146: O2 Sensor Circuit No Activity Detected Bank 1 Sensor 3

> **Quick Answer:** OBD-II fault code P0146 indicates O2 Sensor Circuit No Activity Detected Bank 1 Sensor 3. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0146
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor 3 is a third oxygen sensor on bank 1, behind a second converter or converter brick. It only exists on some vehicles – documented for Jaguar Land Rover's 3.0 V6 supercharged (2013–2016, where sensor 2 is 'mid-cat' and sensor 3 'post-cat') and Ford systems that monitor part of the converter volume. P0146 means sensor 3 produces no voltage of its own and only the control module's bias voltage is seen, as for sensor 2 (P0140): GM evaluates a signal stuck in the 401–548 mV band, a high internal resistance or, with 1900 mV bias, an open circuit. No manufacturer document using exactly this code was found; Jaguar Land Rover lists only P0142–P0144 and P0147 for its sensor 3. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

## Common Symptoms
- Check engine light on (usually after two drive cycles)
- Usually no noticeable change in driving

## Most Likely Root Causes
- Signal or ground wire open, connector off or corroded
- Sensor heater failed, sensor never becomes active
- Sensor worn out (no longer produces voltage)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Bank1 Sensor3.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Bank1 Sensor3.
5. Clear fault memory and run a verification cycle to confirm P0146 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$113 | $54–$270 |
| GBP | £15–£89 | £43–£215 |
| CAD | CA$26–CA$152 | CA$73–CA$363 |
| EUR | €18–€105 | €50–€250 |
| CHF | CHF 21–CHF 121 | CHF 66–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0146?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0146?
DIY replacement parts average $19–$113, while professional service averages $54–$270.

### Will resetting P0146 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

