# OBD-II P0145: O2 Sensor Circuit Slow Response Bank 1 Sensor 3

> **Quick Answer:** OBD-II fault code P0145 indicates O2 Sensor Circuit Slow Response Bank 1 Sensor 3. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0145
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor 3 is a third oxygen sensor on bank 1, behind a second converter or converter brick. It only exists on some vehicles – documented for Jaguar Land Rover's 3.0 V6 supercharged (2013–2016, where sensor 2 is 'mid-cat' and sensor 3 'post-cat') and Ford systems that monitor part of the converter volume. P0145 means sensor 3 reacts too slowly to mixture changes, typically measured around fuel cut-off as for sensor 2 (P0139). No manufacturer document using exactly this code was found – Jaguar Land Rover, the only documented user of sensor 3, does not list it. The description rests on CARB's response-rate requirement for downstream sensors and on the sensor 2 test logic. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

## Common Symptoms
- Check engine light on (usually after two drive cycles)
- Usually no noticeable change in driving

## Most Likely Root Causes
- Sensor aged or contaminated (oil ash, silicone, additives)
- Exhaust leak ahead of the sensor
- Sensor heater weak, sensor too cold

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Bank1 Sensor3.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Bank1 Sensor3.
5. Clear fault memory and run a verification cycle to confirm P0145 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$113 | $65–$270 |
| GBP | £18–£89 | £52–£215 |
| CAD | CA$30–CA$152 | CA$87–CA$363 |
| EUR | €21–€105 | €60–€250 |
| CHF | CHF 24–CHF 121 | CHF 79–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0145?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0145?
DIY replacement parts average $23–$113, while professional service averages $65–$270.

### Will resetting P0145 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

