# OBD-II P0144: O2 Sensor Circuit High Voltage Bank 1 Sensor 3

> **Quick Answer:** OBD-II fault code P0144 indicates O2 Sensor Circuit High Voltage Bank 1 Sensor 3. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0144
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor 3 is a third oxygen sensor on bank 1, behind a second converter or converter brick. It only exists on some vehicles – documented for Jaguar Land Rover's 3.0 V6 supercharged (2013–2016, where sensor 2 is 'mid-cat' and sensor 3 'post-cat') and Ford systems that monitor part of the converter volume. P0144 means the signal of sensor 3 stays above its upper limit, usually because the heater supply or another voltage reaches the signal wire. Ford's over-voltage test (above 1.1 V for 10 s, after 90 s of heating) explicitly covers downstream sensors 2 and 3; Jaguar Land Rover lists the code for its post-cat sensor. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

## Common Symptoms
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness not set
- Usually no noticeable change in driving

## Most Likely Root Causes
- Signal wire shorted to heater supply or battery voltage
- Sensor faulty internally (heater-to-signal short)
- Signal circuit open or high-resistance (GM bias logic)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Bank1 Sensor3.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Bank1 Sensor3.
5. Clear fault memory and run a verification cycle to confirm P0144 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$113 | $65–$270 |
| GBP | £18–£89 | £52–£215 |
| CAD | CA$30–CA$152 | CA$87–CA$363 |
| EUR | €21–€105 | €60–€250 |
| CHF | CHF 24–CHF 121 | CHF 79–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0144?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0144?
DIY replacement parts average $23–$113, while professional service averages $65–$270.

### Will resetting P0144 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

