# OBD-II P0143: O2 Sensor Circuit Low Voltage Bank 1 Sensor 3

> **Quick Answer:** OBD-II fault code P0143 indicates O2 Sensor Circuit Low Voltage Bank 1 Sensor 3. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0143
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
Sensor 3 is a third oxygen sensor on bank 1, behind a second converter or converter brick. It only exists on some vehicles – documented for Jaguar Land Rover's 3.0 V6 supercharged (2013–2016, where sensor 2 is 'mid-cat' and sensor 3 'post-cat') and Ford systems that monitor part of the converter volume. P0143 means the signal of sensor 3 stays below its lower limit – typically a short to ground, or on some systems an open circuit. Jaguar Land Rover assigns it to the post-cat sensor; Ford applies the same pull-up resistance check as for sensor 2 (open above 1 MΩ, short below 10 Ω). Code-specific thresholds for sensor 3 are not published. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

## Common Symptoms
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness not set
- Usually no noticeable change in driving

## Most Likely Root Causes
- Signal wire shorted to ground or melted against the exhaust
- Sensor faulty (cracked element, thermal shock from water)
- Signal circuit open (counts as low on Ford)
- Exhaust leak ahead of the sensor (lean reading)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Bank1 Sensor3.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Bank1 Sensor3.
5. Clear fault memory and run a verification cycle to confirm P0143 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$113 | $65–$270 |
| GBP | £18–£89 | £52–£215 |
| CAD | CA$30–CA$152 | CA$87–CA$363 |
| EUR | €21–€105 | €60–€250 |
| CHF | CHF 24–CHF 121 | CHF 79–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0143?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0143?
DIY replacement parts average $23–$113, while professional service averages $65–$270.

### Will resetting P0143 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

