# OBD-II P0140: O2 Sensor Circuit No Activity Detected Bank 1 Sensor 2

> **Quick Answer:** OBD-II fault code P0140 indicates O2 Sensor Circuit No Activity Detected Bank 1 Sensor 2. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $54–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0140
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The oxygen sensor after the catalytic converter on bank 1 (sensor 2) is a switching sensor (about 0.1–0.9 V) used for converter monitoring and fine mixture trim. P0140 means the sensor produces no voltage of its own and the control module only sees its own reference (bias) voltage. GM's V6 sets it when the signal sits at 401–548 mV or the sensor's internal resistance exceeds 40 kΩ when it should be hot; newer GM systems apply 1900 mV and read above 1700 mV as an open circuit. Two trips. Ford reports 'no activity' under P0136 instead. A cold sensor with a failed heater can also cause it. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

## Common Symptoms
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness not set
- Live data: sensor 2 stuck at about 450 mV (or 1.9 V)

## Most Likely Root Causes
- Signal or ground wire open, connector off or corroded
- Sensor heater failed, sensor never becomes active
- Sensor worn out (no longer produces voltage)
- Control module input faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Bank1 Sensor2.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Bank1 Sensor2.
5. Clear fault memory and run a verification cycle to confirm P0140 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $19–$113 | $54–$270 |
| GBP | £15–£89 | £43–£215 |
| CAD | CA$26–CA$152 | CA$73–CA$363 |
| EUR | €18–€105 | €50–€250 |
| CHF | CHF 21–CHF 121 | CHF 66–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0140?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0140?
DIY replacement parts average $19–$113, while professional service averages $54–$270.

### Will resetting P0140 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

