# OBD-II P013F: O2 Sensor Delayed Response - Lean to Rich Bank 1 Sensor 2

> **Quick Answer:** OBD-II fault code P013F indicates O2 Sensor Delayed Response - Lean to Rich Bank 1 Sensor 2. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p013f
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The downstream oxygen sensor (sensor 2, after the catalytic converter) is used for fine mixture trim and to monitor the converter. 'Delayed response' means the sensor starts reacting too late, or does not reach the target level at all, after the mixture has changed. This code covers the lean-to-rich direction, tested when fuel returns or the control module briefly enriches the mixture. GM checks whether the signal rises above 350 mV before about 75 g of air have passed after the forced change; failing needs two trips. GM investigated this code together with its siblings on 2023–2024 Corvettes with non-original converters or exhaust parts. CARB requires separate detection of slow and delayed faults in each direction (phased in from 2009 for downstream and 2011 for upstream sensors).

## Common Symptoms
- Check engine light on
- Usually no noticeable change in driving
- Catalyst monitor may stay incomplete (inspection readiness missing)
- With a converter cause, P0420/P0430 may follow

## Most Likely Root Causes
- Downstream oxygen sensor aged or contaminated (soot, oil, silicone, coolant)
- Exhaust leak between manifold/turbo and the sensor
- Converter faulty or non-original with different oxygen storage
- Control module software too sensitive (update available)
- Sensor connector or wiring with contact resistance

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Bank1 Sensor2.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Bank1 Sensor2.
5. Clear fault memory and run a verification cycle to confirm P013F does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$113 | $65–$270 |
| GBP | £18–£89 | £52–£215 |
| CAD | CA$30–CA$152 | CA$87–CA$363 |
| EUR | €21–€105 | €60–€250 |
| CHF | CHF 24–CHF 121 | CHF 79–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P013F?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P013F?
DIY replacement parts average $23–$113, while professional service averages $65–$270.

### Will resetting P013F fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

