# OBD-II P0139: O2 Sensor Circuit Slow Response Bank 1 Sensor 2

> **Quick Answer:** OBD-II fault code P0139 indicates O2 Sensor Circuit Slow Response Bank 1 Sensor 2. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0139
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The oxygen sensor after the catalytic converter on bank 1 (sensor 2) is a switching sensor (about 0.1–0.9 V) used for converter monitoring and fine mixture trim. P0139 means the sensor reacts too slowly to mixture changes. Subaru measures it around fuel cut-off: rich to lean from 500 to 300 mV must take no more than 0.51 s, lean to rich from 300 to 500 mV no more than 2 s; two drive cycles set the MIL. CARB requires such a test because a sluggish downstream sensor could let a worn converter pass. Since about 2009–2011 GM and Ford report this as direction-specific codes P013A–P013F instead; P0139 remains in use on older, Asian and Jaguar Land Rover systems. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

## Common Symptoms
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness not set
- P0420 may follow

## Most Likely Root Causes
- Sensor aged or contaminated (oil ash, silicone, additives)
- Exhaust leak ahead of the sensor
- Sensor heater weak, sensor too cold
- High-resistance ground or connector

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Bank1 Sensor2.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Bank1 Sensor2.
5. Clear fault memory and run a verification cycle to confirm P0139 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$113 | $65–$270 |
| GBP | £18–£89 | £52–£215 |
| CAD | CA$30–CA$152 | CA$87–CA$363 |
| EUR | €21–€105 | €60–€250 |
| CHF | CHF 24–CHF 121 | CHF 79–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0139?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0139?
DIY replacement parts average $23–$113, while professional service averages $65–$270.

### Will resetting P0139 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

