# OBD-II P0136: O2 Sensor Circuit Bank 1 Sensor 2

> **Quick Answer:** OBD-II fault code P0136 indicates O2 Sensor Circuit Bank 1 Sensor 2. Usually safe for short trips if no severe drivability or safety warnings are active. Typical professional repair costs $65–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p0136
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Fuel Trim & Air/O2 Metering
- **Severity:** Moderate — Plan Repair
- **Safe to Operate?:** Yes (Short Term)
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The oxygen sensor after the catalytic converter on bank 1 (sensor 2) is a switching sensor (about 0.1–0.9 V) used for converter monitoring and fine mixture trim. P0136 is the general circuit code, and its exact meaning varies by manufacturer. Ford sets it as 'no activity' in a functional check: if the sensor never swings beyond about 0.42/0.48 V despite rich and lean phases – if needed after forced enrichment and leaning – once per drive cycle. Opel/GM Europe set it if the average voltage stays outside 400–500 mV after 10 min of closed loop; older Bosch Motronic if it stays at 0 V for 200 s despite heating. GM North America does not use P0136. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

## Common Symptoms
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness not set
- Slightly higher consumption possible without downstream trim

## Most Likely Root Causes
- Downstream sensor aged or poisoned (stays in the middle band)
- Signal or ground wire open or high-resistance, connector corroded
- Sensor heater failed (sensor stays cold)
- Exhaust leak ahead of the sensor
- Control module or software

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Oxygen Sensor Bank1 Sensor2.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Oxygen Sensor Bank1 Sensor2.
5. Clear fault memory and run a verification cycle to confirm P0136 does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $23–$113 | $65–$270 |
| GBP | £18–£89 | £52–£215 |
| CAD | CA$30–CA$152 | CA$87–CA$363 |
| EUR | €21–€105 | €60–€250 |
| CHF | CHF 24–CHF 121 | CHF 79–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P0136?
Usually safe for short trips if no severe drivability or safety warnings are active.

### How much does it cost to repair P0136?
DIY replacement parts average $23–$113, while professional service averages $65–$270.

### Will resetting P0136 fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

