# OBD-II P012F: Engine Coolant Temperature / Engine Oil Temperature Correlation

> **Quick Answer:** OBD-II fault code P012F indicates Engine Coolant Temperature / Engine Oil Temperature Correlation. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $86–$2700.

- **URL:** https://faultcodes.org/automotive/obd2-p012f
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Professional Recommended
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
P012F compares the coolant temperature sensor with the engine oil temperature sensor. The documented user is Ford's Power Stroke diesel. After a calibration update for the 6.0 litre engine, Ford uses it to monitor oil cooler efficiency: if the oil gets much hotter than the coolant at certain speed and load, the oil-to-coolant heat exchanger is probably clogged, and P012F sets together with the wrench lamp. On the 6.7 litre (2015–2018) several bulletins treat P012F as a false setting – partly below 5 °C ambient – cured by reprogramming the engine module. Ford's 2023 diesels run the cold-start comparison of coolant against oil temperature (35 °C limit after 6 h) under P0196 instead. GM does not use the code, and the code does not say which sensor or which system is at fault.

## Common Symptoms
- Check engine light and/or wrench lamp (Ford)
- Raised oil temperature with a clogged oil cooler
- Often no driving symptoms when software is the cause

## Most Likely Root Causes
- Oil cooler (oil-to-coolant heat exchanger) clogged – oil much hotter than coolant
- Engine module software (false setting, especially in cold weather)
- Coolant or oil temperature sensor inaccurate, or its wiring faulty
- Thermostat stuck open or low coolant
- Block heater in use (only coolant preheated)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Engine Coolant Temperature Sensor.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Engine Coolant Temperature Sensor.
5. Clear fault memory and run a verification cycle to confirm P012F does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $30–$1134 | $86–$2700 |
| GBP | £24–£893 | £69–£2150 |
| CAD | CA$41–CA$1523 | CA$116–CA$3625 |
| EUR | €28–€1050 | €80–€2500 |
| CHF | CHF 32–CHF 1208 | CHF 106–CHF 3300 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P012F?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P012F?
DIY replacement parts average $30–$1134, while professional service averages $86–$2700.

### Will resetting P012F fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

