# OBD-II P012E: Turbocharger/Supercharger Inlet Pressure Sensor A Circuit Intermittent/Erratic

> **Quick Answer:** OBD-II fault code P012E indicates Turbocharger/Supercharger Inlet Pressure Sensor A Circuit Intermittent/Erratic. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p012e
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The turbocharger/supercharger inlet pressure sensor A sits ahead of the compressor – between air filter and turbocharger, or on GM's supercharged V8 between throttle and supercharger. It is an analogue 5 V pressure sensor used for the compressor pressure ratio, filter restriction and cross-checks with the other pressure sensors. P012E covers a signal that jumps or drops out briefly without staying below or above the circuit limits – typically a loose contact. Such intermittent monitors usually count short limit violations or changes faster than real pressure can move. No manufacturer document using exactly this code was found: GM handles jumps of this sensor through its range check P012B and the counting windows of P012C/P012D, and Ford's 2023 diesels report their digital sensor under P012A. The description therefore rests on CARB's circuit monitoring requirement and component information. A substitute value is used while the fault is present.

## Common Symptoms
- Check engine light on
- Occasional power reduction or boost fluctuation
- Often no noticeable symptoms

## Most Likely Root Causes
- Loose contact or corrosion at the sensor connector
- Broken or chafed wire making intermittent contact
- Sensor faulty internally (erratic output)
- Control module or software

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Turbocharger Inlet Pressure Sensor A.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Turbocharger Inlet Pressure Sensor A.
5. Clear fault memory and run a verification cycle to confirm P012E does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P012E?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P012E?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P012E fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

