# OBD-II P012D: Turbocharger/Supercharger Inlet Pressure Sensor A Circuit High

> **Quick Answer:** OBD-II fault code P012D indicates Turbocharger/Supercharger Inlet Pressure Sensor A Circuit High. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$324.

- **URL:** https://faultcodes.org/automotive/obd2-p012d
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Moderate (Intermediate)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The turbocharger/supercharger inlet pressure sensor A sits ahead of the compressor – between air filter and turbocharger, or on GM's supercharged V8 between throttle and supercharger. It is an analogue 5 V pressure sensor used for the compressor pressure ratio, filter restriction and cross-checks with the other pressure sensors. P012D means the signal voltage is above its upper limit – typically the signal wire shorted to the 5 V reference or battery voltage, or an open sensor ground that lets the signal rise to the reference. GM's supercharged LT4/LT5 sets it above 97 % of the reference (about 124 kPa) with 320 of 400 samples failing, monitored continuously; two trips on the LT4, one on the 2019 LT5. FCA documented false settings on the 2019 Jeep Wrangler 2.0 turbo, fixed by new engine software. The control module substitutes a modelled or ambient value and may limit boost.

## Common Symptoms
- Check engine light on
- Reduced power or limp mode possible
- Often no noticeable symptoms

## Most Likely Root Causes
- Signal wire shorted to 5 V reference or battery voltage
- Sensor ground open or connector corroded
- Sensor faulty internally
- Control module software (false setting)

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Turbocharger Inlet Pressure Sensor A.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Turbocharger Inlet Pressure Sensor A.
5. Clear fault memory and run a verification cycle to confirm P012D does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$136 | $43–$324 |
| GBP | £13–£107 | £34–£258 |
| CAD | CA$22–CA$183 | CA$58–CA$435 |
| EUR | €15–€126 | €40–€300 |
| CHF | CHF 17–CHF 145 | CHF 53–CHF 396 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P012D?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P012D?
DIY replacement parts average $16–$136, while professional service averages $43–$324.

### Will resetting P012D fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

