# OBD-II P012C: Turbocharger/Supercharger Inlet Pressure Sensor A Circuit Low

> **Quick Answer:** OBD-II fault code P012C indicates Turbocharger/Supercharger Inlet Pressure Sensor A Circuit Low. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p012c
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The turbocharger/supercharger inlet pressure sensor A sits between the air filter and the compressor. The engine uses it for the compressor pressure ratio, to judge air filter restriction (ambient minus inlet pressure) and to cross-check the other pressure sensors. P012C means the signal voltage is below its lower limit – typically a signal wire shorted to ground, an open signal or 5 V reference wire, or a failed sensor. GM's supercharged V8 sets it below 3 % of the 5 V reference (about 0.15 V), with 320 of 400 samples failing, continuously monitored; two trips are normal, one in some 2019 applications. FCA documented false settings on the 2019 Jeep Wrangler 2.0 turbo that were cured by a software update. A substitute value is used and power may be limited.

## Common Symptoms
- Check engine light on
- Often no noticeable symptoms
- Power limitation possible

## Most Likely Root Causes
- Connector unplugged or corroded, signal or reference wire open
- Signal wire shorted to ground
- Sensor failed internally
- Control module software (false setting)
- 5 V reference shorted by another sensor

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Turbocharger Inlet Pressure Sensor A.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Turbocharger Inlet Pressure Sensor A.
5. Clear fault memory and run a verification cycle to confirm P012C does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P012C?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P012C?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P012C fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

