# OBD-II P012B: Turbocharger/Supercharger Inlet Pressure Sensor A Circuit Range/Performance

> **Quick Answer:** OBD-II fault code P012B indicates Turbocharger/Supercharger Inlet Pressure Sensor A Circuit Range/Performance. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p012b
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The turbocharger/supercharger inlet pressure sensor A sits between the air filter and the compressor. The engine uses it for the compressor pressure ratio, to judge air filter restriction (ambient minus inlet pressure) and to cross-check the other pressure sensors. P012B is a plausibility fault: the signal is electrically valid but stuck or offset. On GM's supercharged 6.2 V8 the sensor must read 50–115 kPa and agree within 10 kPa with MAP and ambient pressure after the engine has been off for more than 8 s; while running, it is compared with modelled values (fault above about 25–30 kPa). GM normally needs two trips, one in some 2019 applications. In operation inlet pressure is slightly below ambient because of filter losses, so a clogged filter or blocked intake lowers it further.

## Common Symptoms
- Check engine light on
- Loss of power or boost limitation
- Possibly no noticeable symptoms

## Most Likely Root Causes
- Sensor oiled (crankcase vent often joins before the compressor) or drifted
- Air filter heavily clogged or intake blocked or collapsed
- Leak in the intake pipe between filter and compressor or at the sensor flange
- High resistance in the wiring
- Comparison sensor (MAP, baro, MAF) wrong or software

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Turbocharger Inlet Pressure Sensor A.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Turbocharger Inlet Pressure Sensor A.
5. Clear fault memory and run a verification cycle to confirm P012B does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P012B?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P012B?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P012B fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

