# OBD-II P012A: Turbocharger/Supercharger Inlet Pressure Sensor A Circuit

> **Quick Answer:** OBD-II fault code P012A indicates Turbocharger/Supercharger Inlet Pressure Sensor A Circuit. Avoid prolonged operation until inspected to prevent secondary component damage. Typical professional repair costs $43–$270.

- **URL:** https://faultcodes.org/automotive/obd2-p012a
- **Category:** Automotive & OBD-II
- **Brand / Standard:** OBD-II
- **System Area:** Engine Cooling & Thermostat
- **Severity:** High — Service Soon
- **Safe to Operate?:** No — Risk of Damage
- **DIY Difficulty:** Easy (Basic Tools)
- **Updated:** 2026-11-22T05:56:37+00:00

## What This Fault Code Means
The turbocharger/supercharger inlet pressure sensor A sits between the air filter and the compressor. The engine uses it for the compressor pressure ratio, to judge air filter restriction (ambient minus inlet pressure) and to cross-check the other pressure sensors. P012A is the general circuit fault. Ford's 2023 diesels use a digital SENT sensor here and set P012A when its error flag is raised or the value exceeds a limit for 5 s; lost communication is reported separately (U068B). FCA's 2019 Jeep Wrangler 2.0 turbo could set P012A, P012C and P012D falsely and was fixed with new engine software, so the software level is worth checking before replacing parts. GM's supercharged V8 uses only P012B–P012D. A substitute value, usually ambient pressure, is used.

## Common Symptoms
- Check engine light on
- Often no noticeable symptoms
- Power limitation possible

## Most Likely Root Causes
- Connector or wiring open, corroded or shorted
- Sensor faulty (SENT sensor reports internal error)
- Control module software (false setting)
- Engine control module faulty

## Step-by-Step Troubleshooting & Fix
1. Scan for companion fault codes and address upstream circuit issues first.
2. Visually inspect wiring harnesses, plugs, and hoses around Turbocharger Inlet Pressure Sensor A.
3. Test component voltage, resistance, or mechanical actuation with diagnostic tools.
4. Repair damaged wiring or install an OEM-grade replacement Turbocharger Inlet Pressure Sensor A.
5. Clear fault memory and run a verification cycle to confirm P012A does not return.

## Estimated Repair Cost Benchmark
| Currency | DIY Parts Only | Professional Repair (Parts + Labor) |
| --- | --- | --- |
| USD | $16–$113 | $43–$270 |
| GBP | £13–£89 | £34–£215 |
| CAD | CA$22–CA$152 | CA$58–CA$363 |
| EUR | €15–€105 | €40–€250 |
| CHF | CHF 17–CHF 121 | CHF 53–CHF 330 |

## Frequently Asked Questions
### Is it safe to keep operating with fault code P012A?
Avoid prolonged operation until inspected to prevent secondary component damage.

### How much does it cost to repair P012A?
DIY replacement parts average $16–$113, while professional service averages $43–$270.

### Will resetting P012A fix the problem permanently?
No. Clearing the fault code only removes the stored alert temporarily; the code returns if the underlying fault persists.

